HM Electronics Inc XCVR2G4A Manuel D’Utilisation
User Guide | FreeSpeak II™
Page 63
Figure 6-16 Adding members to a group
4)
Scroll through the pages of this list to find the desired members for the
group. When a desired member is highlighted, press the setup/enter
encoder to select that member. A box appears around it.
group. When a desired member is highlighted, press the setup/enter
encoder to select that member. A box appears around it.
5)
To de-select a member that has already been selected, highlight that
member and press the setup/enter encoder. Pressing the setup/enter
encoder effectively works as a toggle switch, first selecting the item by
putting a box around it, and then de-selecting it and removing the box.
member and press the setup/enter encoder. Pressing the setup/enter
encoder effectively works as a toggle switch, first selecting the item by
putting a box around it, and then de-selecting it and removing the box.
6)
When all of the desired beltpack labels and Base station port labels have
been selected, scroll clockwise to BACK and select it to exit the selection
process. Continue selecting the BACK command until the desired screen is
reached.
been selected, scroll clockwise to BACK and select it to exit the selection
process. Continue selecting the BACK command until the desired screen is
reached.
7)
The changes are saved and applied automatically five seconds after the
last time the setup/enter encoder was pressed or turned. The front-panel
display flashes to indicate that the changes are being saved and applied.
last time the setup/enter encoder was pressed or turned. The front-panel
display flashes to indicate that the changes are being saved and applied.
To edit a group that already has members, go through the procedure above to
reach the member labels. Scroll through the list, using presses of the rotary
encoder to select and de-select members. Exit as above, and save the changes in
the system memory.
reach the member labels. Scroll through the list, using presses of the rotary
encoder to select and de-select members. Exit as above, and save the changes in
the system memory.
6.8
Beltpacks
The following steps have been completed in setting up the system:
•
Created names (“labels”) for the FS II beltpacks and for the devices wired
to the Base station’s rear panel
to the Base station’s rear panel
•
Created names (“labels”) for communication groups and assigned
members to the each group.
members to the each group.
6.9
Assigning audio routes to a beltpack
The next step is to assign communication routes to the individual FS II beltpacks.
For this example, communication routes are assigned to the beltpack in position
one—BPK01. The procedure is identical for all remaining beltpacks.
one—BPK01. The procedure is identical for all remaining beltpacks.
1)
From the MAIN menu, select BELTPACKS.