SEA Inc of Delaware ESP1100 Manuel D’Utilisation
FCC ID: BZ6ESP1100
Page 12-3
BASESTN mode does not use an external trunking controller. In BASESTN mode, the
1100 transmits audio present at the ACC2 TXAF pin when keyed from ACC2. Received
audio is routed to the ACC2 RX AF pin. Half-second turnoff code bursts are transmitted
by the 1100 every 5,10, or 15 minutes to update mobile radio frequency tracking
memories.
1100 transmits audio present at the ACC2 TXAF pin when keyed from ACC2. Received
audio is routed to the ACC2 RX AF pin. Half-second turnoff code bursts are transmitted
by the 1100 every 5,10, or 15 minutes to update mobile radio frequency tracking
memories.
An abbreviated version of the "Quickstart Procedure" from the 1100 manual page 6-40 is
given below, modified for DDS operation.
given below, modified for DDS operation.
1.
Determine RF Channel Numbers - same as in 1100 manual
2.
Access Setup/Program Mode - same as in 1100 manual
3.
Program Frequencies - same as in 1100 manual
4.
Select BASESTN Operation:
a.
Press 7# from the PM= prompt. Display is TRUNKED, CONVENTL, or
BASESTN.
BASESTN.
b.
Press 0 until display reads BASESTN.
5.
Press #. Display is AREA=0 or AREA=1. Press 0 or 1 to select the proper area
bit for the repeater system.
bit for the repeater system.
6.
Press #. Display is HOME=01,02, etc. Enter the normal home channel number
for the repeater.
for the repeater.
7.
Press #. Display is TOCRT=00,05,10, or 15.
Press 0 until the display reads the desired time interval (minutes) between
automatic turnoff code transmissions. Suggested value = 10 minutes. 00 = no
automatic turnoff codes.
automatic turnoff code transmissions. Suggested value = 10 minutes. 00 = no
automatic turnoff codes.
8.
Press #. Display is TOTE=N or Y.
Press 0 so display read TOTE=N. This disables the transmit timeout timer.
9.
Press #, then 99#. Display is ESP1100 and unit is ready for operation in
basestation mode.
basestation mode.