Winegard Company WFAP01 Manuel D’Utilisation
WF‐AP01 Quick Start Guide:
Ensure that your device is powered on.
Connecting a device to the WG‐AP01:
1. Select the Winegard Connect Network listed on the label on the back of the WG‐AP01 shown below
after the Default SSID:
Once selected, the WG‐AP01 will ask for a Password. Enter the Default
Password on the back of the WG‐AP01. Now that the device is connected to the WG‐AP01, the system is ready to
browse.
browse.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause undesired operation.
this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following methods:
provide reasonable protection against harmful interference in a residential installation. This equipment uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following methods:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and devices.
Connect the equipment into an electrical outlet on a circuit different from that which the radio receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
Only channel 1~11 can be operated. Selection of other channels is not possible.
This device and its antenna(s) must not be co‐located or operation in conjunction with any other antenna or transmitter.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with
minimum distance 25cm between the radiator and your body.
minimum distance 25cm between the radiator and your body.
This device and its antenna(s) must not be co‐located or operating in conjunction with any other antenna or transmitter except in accordance
with FCC multi‐transmitter product procedures.
with FCC multi‐transmitter product procedures.