Dynamics Hong Kong Limited GRAVITYPRO Manuel D’Utilisation

Page de 49
 
 
48 
 Do not touch the antenna unnecessarily when the phone is in use. Contact with the antenna 
affects  call  quality  and  may  cause  the  phone  to  operate  at  a  higher  power  level  than  otherwise 
needed. 
 
RF Exposure Information: 
FCC RF Exposure requirements: The highest SAR value reported under this standard during 
product certification for use next to the body with the  minimum separation distance of 0.5cm is 
0.759W/kg; next to the head is 0.463W/kg. This transmitter must not be collocated or operating in 
conjunction with any other antenna or transmitter. 
 
This device complies with part 15 of the FCC rules. Operation is subject to the following two 
conditions: 
(1) this device may not cause harmful interference, and 
(2) this device must accept any interference received, including interference that may cause 
undesired operation. 
 
NOTE:  The  manufacturer  is  not  responsible  for  any  radio  or  TV  interference  caused  by 
unauthorized modifications to this equipment. Such modifications could void the user’s authority 
to operate the equipment. 
NOTE:  This equipment  has  been  tested and  found to comply  with  the  limits  for a  Class B 
digital  device,  pursuant  to  part  15  of  the  FCC  Rules.  These  limits  are  designed  to  provide 
reasonable  protection  against  harmful  interference  in  a  residential  installation.  This  equipment 
generates uses and can radiate radio frequency energy and, if not installed and used in accordance 
with the instructions, may cause harmful interference to radio communications. However, there is 
no  guarantee  that  interference  will  not  occur  in  a  particular  installation.  If  this  equipment  does 
cause harmful  interference  to  radio or television  reception,  which can be  determined by  turning 
the equipment off and on, the user is encouraged to try to correct the interference by one or more 
of the following measures: 
 
- Reorient or relocate the receiving antenna. 
- Increase the separation between the equipment and receiver. 
-Connect the equipment into an outlet on a circuit different from that to which the receiver is 
connected. 
-Consult the dealer or an experienced radio/TV technician for help 
 
Do not use the device with the environment which below minimum -10℃  or over maximum 
50℃, the device may not work. 
 
  Changes or  modifications to this unit  not  expressly  approved by  the party  responsible  for 
compliance could void the user’s authority to operate the equipment. 
This device is acting as host device and operating in the 2.4 GHz (2412 – 2462 MHz) band.   
Ad Hoc function is supported but not able to operate on non-US frequencies.