Tait Limited TBBH7F Manuel D’Utilisation
TB7
200 Installation and Operation Manual Installation 5
© Tait Electronics Limited December 2004
Installation
This chapter describes how to install the TB7200 base station in a standard
19 inch rack or cabinet. It also provides some general information on safety
precautions and site requirements. We recommend that you read the entire
chapter before beginning the installation.
19 inch rack or cabinet. It also provides some general information on safety
precautions and site requirements. We recommend that you read the entire
chapter before beginning the installation.
1.1
Personal Safety
1.1.1
Explosive Environments
Warning!! Do not operate TB7
200 base station equipment
near electrical blasting caps or in an explosive
atmosphere. Operating the equipment in these
environments is a definite safety hazard.
atmosphere. Operating the equipment in these
environments is a definite safety hazard.
1.1.2
Proximity to RF Transmissions
Do not operate the transmitter when someone is standing within 90 cm (3ft)
of the antenna. Do not operate the transmitter unless you have checked that
all RF connectors are secure.
of the antenna. Do not operate the transmitter unless you have checked that
all RF connectors are secure.
1.2
Equipment Safety
1.2.1
ESD Precautions
Important
This equipment contains devices which are susceptible to
damage from static charges. You must handle these devices
carefully and according to the procedures described in the
manufacturers’ data books.
damage from static charges. You must handle these devices
carefully and according to the procedures described in the
manufacturers’ data books.
We recommend you purchase an antistatic bench kit from a reputable
manufacturer and install and test it according to the manufacturer’s
instructions.
manufacturer and install and test it according to the manufacturer’s
instructions.
Figure 1.1
shows a typical antistatic bench set-up.
You can obtain further information on antistatic precautions and the dangers
of electrostatic discharge (ESD) from standards such as ANSI/ESD
S20.20-1999 or BS EN 100015-4 1994.
of electrostatic discharge (ESD) from standards such as ANSI/ESD
S20.20-1999 or BS EN 100015-4 1994.