Johnson Controls Interiors L.L.C. 051AHL4 Manuel D’Utilisation

 
 
The HomeLink Wireless Control System provides a convenient way to replace up to three hand-
held radio-frequency (RF) transmitters used to activate devices such as gate operators, garage 
door openers, entry door locks, security systems, even home lighting.     Additional HomeLink 
information can be found on the Internet at 

. 

 
Precautions! 
 
Before programming HomeLink to a garage door opener or gate operator, make sure that people 
and objects are out of the way of the device to prevent potential harm or damage.  When 
programming a garage door opener, it is advised to park outside of the garage.  Do not use 
HomeLink with any garage door opener that lacks safety stop and reverse features as required 
by U.S. federal safety standards (this includes any garage door opener model manufactured 
before April 1, 1982). A garage door that cannot detect an object - signaling the door to stop and 
reverse - does not meet current U.S. federal safety standards. For more information, contact 
HomeLink at:  

 
Retain the original transmitter of the RF device you are programming for use in other vehicles as 
well as for future HomeLink programming.    It is also suggested that upon the sale of the vehicle, 
the programmed HomeLink buttons be erased for security purposes.  Refer to “Erasing 
HomeLink Buttons”. 
 
Programming HomeLink 
 
Note: Some vehicles may require the ignition switch to be turned on or to the second 
(“accessories”) position for programming and/or operation of HomeLink.  It is also recommended 
that a new battery be placed in the hand-held transmitter of the device being programmed to 
HomeLink for quicker training and accurate transmission of the radio-frequency signal.     
 
1.  Position the end of your hand-held transmitter 1–3 inches (5–14 cm) away from the 

HomeLink button you wish to program while keeping the indicator light in view. 

 
2.  Simultaneously press and hold both the chosen HomeLink and hand-held transmitter buttons 

until the HomeLink indicator light changes from a slow to a rapidly blinking light.  Now you 
may release both the HomeLink and hand-held transmitter buttons. 

Note:  Some devices may require you to replace this Programming Step 2 with procedures 
noted in the “Gate Operator / Canadian Programming” section.  If the HomeLink indicator 
light does not change to a rapidly blinking light after performing these steps, contact 
HomeLink at 

www.homelink.com

. 

 
 

3. Firmly 

press, hold for five seconds and release the programmed HomeLink button up to 

two separate times to activate the door.  If the door does not activate, press and hold the just-
trained HomeLink button and observe the indicator light.   
 

•  If the indicator light stays on constantly, programming is complete and your 

device should activate when the HomeLink button is pressed and released.   

 

•  If the indicator light blinks rapidly for two seconds and then turns to a constant 

light continue with “Programming” steps 4-6 to complete the programming of a 
rolling code equipped device (most commonly a garage door opener).