Kelvin Hughes Limited SXV-A1 Manuel D’Utilisation
SharpEye™ SCV & SxV X-Band Radome Radar
Chapter 6: Mechanical installation
KH-1650-CA issue 1
Page 26 of 60
INSTALLATION PROCEDURE
A. Invert the SCV assembly ensuring the unit is placed on a surface that will not damage or scratch
the top of the radome casing.
B. SCV-A170 cable bracket assembly rests in-between the two connectors as shown below.
C. The SCV-A172 anti-vibration plate is fitted with four anti-vibration mounts. One of these mounts
has longer fasteners that protrude below the plate. These longer fasteners align with the slots in
the SCV-A170 cable bracket assembly and are secured using the M4 fasteners, plain and spring
washers found in the fitting kit.
TIP: Fit the anti-vibration plate to the cable bracket assembly and loosely tighten the 4 longer fasteners. Align the cable
bracket assembly then align the anti-vibration plate with the 4 main fastening holes on the base of the transceiver.
The assembly can then be removed and the longer shock mount screws can be fully tightened.
D. The assembly can be fastened to the SCV using the M8 x 25mm bolts, plain and spring washers
provided in the fitting kit.
E. Tighten the main bolts to a torque of 22Nm (see precautions in section 6.3).
EXAMPLE OF MOUNTING
SCV-A170 cable bracket
assembly placed onto an
SCV.
SCV-A172 anti-vibration
plate showing the four longer
mounting fasteners (circled)
that align with the A170
cable bracket assembly.
Completed assembly shown
prior to the four mounting
bolts being fitted.
Example of bolt and washer
arrangement