Tianjin Tiandy Digital Technology Co. Ltd. TIANDY-PTZ Manuel D’Utilisation
Chapter 4 Installation Guide
1、Take out the bracket and unscrew the power box from the bracket.
2、Thread cables across the bracket and connect them to the circuit board in the
power box.
Install the dome body to the bracket, screw up with 4 inner hexagon screws. If
necessary, apply water-proof glue to the joint gap.
power box.
Install the dome body to the bracket, screw up with 4 inner hexagon screws. If
necessary, apply water-proof glue to the joint gap.
3、unscrew the cover with the mark “SET”, set communication protocol and
addresses. Screw up again with care to avoid water.After the installation of dome
body, use two outer hexagon screws to tighten
bracket and power box.
addresses. Screw up again with care to avoid water.After the installation of dome
body, use two outer hexagon screws to tighten
bracket and power box.