Broadcast Microwave Services Inc CCII-4H Manuel D’Utilisation
Broadcast Microwave Services, Inc. – 12367 Crosthwaite Circle – Poway, CA 92064
10
Phone: 800-669-9667, 1-858-391-3050 - Fax: 1-858-391-3049
Email:
support@bms-inc.com
Web:
www.bms-inc.com
•
Regardless of the mobile and fixed applications the installation procedure for transmitter site will be similar as explained in
the following section:
the following section:
Installation Procedure
The 4GHz Carry-Coder II with Power Amplifier can be installed inside a vehicle such as a truck. The symbolic diagram of the
installation is given in Figure 3. The installation procedure is as follows:
installation is given in Figure 3. The installation procedure is as follows:
1. Install the omni-directional antenna on the vehicle roof-top using the brackets and instructions that are supplied in the
accessory kit.
2. Secure the Carry-Coder II transmitter and the Power Amplifier inside the truck. The two units may be one or 2 feet apart.
3. To ensure sufficient ventilation, at least 3” clearance is recommended from each side of the units.
•
3. To ensure sufficient ventilation, at least 3” clearance is recommended from each side of the units.
•
Using N-type coaxial cable (about 3 feet long) connect the output of the Carry-Coder II transmitter to the input of the Power
Amplifier.
Amplifier.
•
Using Coaxial cable and N to SMA adaptor, connect the output of the Power Amplifier to the SMA input port of the omni
antenna.
antenna.
•
Using the special power cords connect the Transmitter and the Power Amplifier to the 12V DC voltage.
•
Connect the interface cables from the camera to the appropriate CARRY-CODER II connector(s).
•
Using the supplied Remote Control Display, set the Transmitter frequency, power, modulation scheme …etc. as will be
explained in the next section.
explained in the next section.
Installing the Battery on the Carry-Coder II
The Carry-Coder II can be run by its own battery as well. The procedure for battery installation is as follows:
•
Slide the battery in to the receptacle located underneath the CCII until it locks into place
•
Connect the power cable coming from the battery connector socket to the CARRY-CODER II.
•
Switch on the power for the camera and the CARRY-CODER II.