ActiGraph LLC 02 Manuel D’Utilisation
www.theactigraph.com
P a g e
| 10
49 E. Chase St. Pensacola, FL 32502 tel 850.332-7900 fax 850-332-7904
Introduction
The wGT3X-BT activity monitors provide objective measurements of human activity and are used in
many research and clinical applications. They include a microelectromechanical system (MEMS) based
accelerometer, ambient light, and a touch sensor as data collection end points. No formal training is
required to use the wGT3X-BT device and patients may be the intended operator. This document will
serve as the only necessary training guide needed to get full functionality from the device.
many research and clinical applications. They include a microelectromechanical system (MEMS) based
accelerometer, ambient light, and a touch sensor as data collection end points. No formal training is
required to use the wGT3X-BT device and patients may be the intended operator. This document will
serve as the only necessary training guide needed to get full functionality from the device.
Specifications and Functionality of the wGT3X-BT
Data
The devices include both an acceleration sensor as well as an ambient light sensor. Data will not be
negatively affected by lint, dust, or direct sunlight.
negatively affected by lint, dust, or direct sunlight.
Acceleration
The devices include an acceleration sensor that consists of a microelectromechanical systems (MEMS)
accelerometer yielding the following product specifications:
accelerometer yielding the following product specifications:
Parameter
Value
Units
Axis
3
Sensitivity
4
mg/LSB
Dynamic Range
+/- 8
g
Table 1 – Accelerometer Key Specifications
The acceleration data is stored at rates ranging from 30 Hz to 100 Hz (user selectable) and stored in a
raw, non-filtered/accumulated format in the units of gravity (g’s). This data is stored directly into a non-
volatile flash memory. The accelerometer is very sensitive and is accurate within +/- 0.5% of the data
collected.
raw, non-filtered/accumulated format in the units of gravity (g’s). This data is stored directly into a non-
volatile flash memory. The accelerometer is very sensitive and is accurate within +/- 0.5% of the data
collected.
Ambient Light
Ambient light data is sampled and stored to memory at a 1 Hz rate. When a downloaded data file is
converted into an accumulated *.agd format with epoch lengths greater than one second, the lux values
for that epoch are averaged. An estimate of lux values is shown in Table 1.
converted into an accumulated *.agd format with epoch lengths greater than one second, the lux values
for that epoch are averaged. An estimate of lux values is shown in Table 1.
Lux Level
Interpretation Comparison
1
Twilight
50
Family living room