3M Company OPTICOMGPS1 Manuel D’Utilisation
Vehicle Equipment Installation Instructions
12
1. Disconnect the battery before beginning the
installation. Disconnect the negative battery cable
first, then the positive battery cable.
first, then the positive battery cable.
2. Remove interior panels and headliners, as
necessary, to provide access for cable routing.
3. Determine an appropriate location in a protected
area inside of the vehicle or trunk.
4. Using the provided screws, attach the Radio/GPS
unit to the mounting location.
5. The provided screws are self drilling/tapping
screws.
Note: The radio/GPS unit is not watertight;
therefore it should be mounted inside the
passenger compartment or some other protected
area of the vehicle.
therefore it should be mounted inside the
passenger compartment or some other protected
area of the vehicle.
WARNING
Vehicle batteries contain sulfuric acid and
may contain explosive gases. Keep sparks,
flames, and cigarettes away. Wear eye
protection. Disconnect the negative
cable first to prevent shorting the
positive terminal to the chassis when
removing the positive cable. Battery acid
may cause skin irritation and eye injury.
Explosive gases may cause severe injury or
death.
may contain explosive gases. Keep sparks,
flames, and cigarettes away. Wear eye
protection. Disconnect the negative
cable first to prevent shorting the
positive terminal to the chassis when
removing the positive cable. Battery acid
may cause skin irritation and eye injury.
Explosive gases may cause severe injury or
death.
Figure 5-1. Mounting Radio/GPS Unit on Priority Vehicle
1. Vehicle radio/GPS unit
2. Mounting screws (4)