3M Company OPTICOMGPS1 Manuel D’Utilisation

Page de 29
4 
Vehicle Equipment Installation Instructions 
2.4  Safety Messages Contained in this 
Manual 
The following safety messages appear in this manual: 
  
WARNING
 
This equipment has been approved for mobile 
applications where the equipment should be 
used at distances greater than 20cm from the 
human body (with the exception of hands, wrists, 
feet and ankles).  Operation at distances less 
than 20cm is strictly prohibited. 
NOTE 
This equipment has been tested and found to 
comply with the limits for a Class A digital 
device, pursuant to part 15 of the FCC Rules.  
These limits are designed to provide 
reasonable protection against harmful 
interference when the equipment is operated 
in a commercial environment.  This 
equipment generates, uses, and can radiate 
radio frequency energy and, if not installed 
and used in accordance with the instruction 
manual, may cause harmful interference to 
radio communications.  Operation of this 
equipment in a residential area is likely to 
cause harmful interference in which case the 
user will be required to correct the 
interference at his own expense. 
NOTICE 
This Class A digital apparatus complies with 
Canadian ICES-003. 
Cet appareil numérique de la classe A 
conforme à la norme NMB-003 du Canada. 
 
  
IMPORTANT NOTE
 
Modifying the radio/GPS unit may seriously 
damage the equipment and void the warranty.  
Do not attempt to modify the radio/GPS 
circuitry in any way.
  Modifying the radio 
and/or antenna in any way may cause the radio 
to violate FCC requirements. 
 
 
 
  
WARNING
 
Vehicle batteries contain sulfuric acid and 
may contain explosive gases.  Keep sparks, 
flames, and cigarettes away.  Wear eye 
protection.  Disconnect the negative 
cable first to prevent shorting the positive 
terminal to the chassis when removing 
the positive cable.
  Battery acid may cause 
skin irritation and eye injury.  Explosive gases 
may cause severe injury or death. 
 
 
 
  
WARNING
 
A completed installation that is not tested may 
result in improper system operation, which may 
result in accidents and/or injuries.  To avoid 
this problem, test the system to verify 
proper operation.
  Improper system operation 
may result in unsafe driver action.