OMG plc VICP1 Manuel D’Utilisation
Origin
Setup &
Maintenance
Guide
Setup &
Maintenance
Guide
Vicon Motion Systems Ltd.
04-Sep-2018
Page 18 of 45
Replace a failed cluster
Depending on the failure mode, the affected cluster may show as
disconnected (red X icon) on the System tab, or it may show error icons.
To replace a cluster:
1. Turn off the failed cluster using the power button.
2. Ensure that the replacement cluster is paired with the Beacon in the
volume.
3. Replace the failed cluster with the replacement cluster and turn on the
replacement.
To assign the pattern from the failed cluster:
1. Ensure the replacement cluster is displayed in the System tab with a
blue connection status icon (connected but not programmed with a
marker pattern).
2. On the System tab, select it and from the Pattern drop-down list,
choose the pattern matching the device location.
Note that unassigned patterns or patterns assigned to a disconnected
device are displayed at the top of the list.
Check that the connection status turns green (active and programmed
with a marker pattern).
DRAFT