Wyse Technology WT3320 Manuel D’Utilisation
57
Removal
Refer to the three figures in this section and proceed as follows:
1. Turn off the power.
2. Disconnect the cable assembly from the modem card by depressing the
connector tabs and pulling the connector out of the card (see the preceding
figure).
figure).
3. Remove the two screws securing the terminal back panel (part of logic card
assembly), and pull the panel out approximately 1/2 inch.
4. Remove the option slot cover screw.
5. Open the option slot cover. Press down on top of the cover to release the top
catches and swing the cover out and down (see the figure titled “Installing the
Modem Card”).
Modem Card”).
Caution
Do not try to open the cover with the logic card
assembly fully seated. The cover could be damaged.
assembly fully seated. The cover could be damaged.
6. Pull the modem card out of the option slot.
7. Close the option slot cover (see the figure titled “Connecting the Modem Card
Cable”).
8. Push the logic card assembly back into the unit and reinstall the two screws
removed in step 3.
9. Install the option slot cover screw.
10.Snap the plug into the option slot cover hole (see the following figure).
11.Disconnect the cable assembly from the telephone jack.
Note
Leave the clamp-on noise suppressor on the cable
assembly (may not be applicable to other vendors’
cables).
assembly (may not be applicable to other vendors’
cables).