Rockwell Collins Inc. 8222210 Manuel D’Utilisation

Follow these steps to issue the Cisco IOS command for your power scenario:

Connect a PC to the access point console port and use a terminal emulator to establish a session with the 
access point (refer to the 

From the privileged EXEC mode (refer to the 

the command below that applies to your power configuration (see 

power inline negotiation injector xxxx.xxxx.xxxx 
(where xxxx.xxxx.xxxx is the MAC address of the switch port to which the access point is 
connected)

The MAC address might be available from the Inline Power Status message.

Enter the write memory command to save the setting to the access point memory.

Enter the quit command to exit the terminal session.

Power injector

2 

used with a Cisco switch that 

does not support Intelligent Power 
Management

1

power inline negotiation injector xxxx.xxxx.xxxx 
(where xxxx.xxxx.xxxx is the MAC address of the 
switch port to which the access point is connected) 

The MAC address might be available from the 
Inline Power Status message.

Power injector used with a non-Cisco switch

None required

– 

802.3af compliant non-Cisco switches

None required

–

1.

You should check the release notes for your Cisco power source to determine which Cisco IOS release supports Intelligent Power Management. Support 
for Intelligent Power Management might not be currently available for your Cisco power source.

2.

Power injector must be AIR-PWRINJ3 or AIR-PWRINJ-FIB.

3.

Cisco switches that support Intelligent Power Management always configure the use of a power injector at the switch.