Rockwell Collins Inc. 8223543 Manuel D’Utilisation
SSR-7610
General warnings and cautions and related safety data
WARNING
General warnings and cautions and related safety data
WARNING
Before you touch a unit or a component, ground your body with a conductive wrist
strap or other device. The device must use a 470K OHM (Ω) or 1M Ω series resistor
that limits current through the wrist strap to ground.
strap or other device. The device must use a 470K OHM (Ω) or 1M Ω series resistor
that limits current through the wrist strap to ground.
WARNING
Obey the standard safety precautions to prevent injury while you install or work
on this unit. For example wear safety glasses.
on this unit. For example wear safety glasses.
WARNING
This unit could have parts that contain dangerous materials. For example beryllium
oxide, acids, lithium, radioactive material, mercury or more. These materials can be
dangerous to you. To prevent injury from dangerous materials, read OSHA document
29CFR 1910.1000 (or its replacement document) when a part with dangerous materials
breaks. If you do not know if a part contains dangerous materials, DO NOT open or
disassemble it.
oxide, acids, lithium, radioactive material, mercury or more. These materials can be
dangerous to you. To prevent injury from dangerous materials, read OSHA document
29CFR 1910.1000 (or its replacement document) when a part with dangerous materials
breaks. If you do not know if a part contains dangerous materials, DO NOT open or
disassemble it.
WARNING
Be careful around sealants, solvents and other chemical compounds. Do not put the
chemical compounds in high heat or near open flame. Use only with sufficient airflow.
DO NOT breathe the fumes. Prevent long contact with skin. Obey the manufacturer
warnings and cautions.
chemical compounds in high heat or near open flame. Use only with sufficient airflow.
DO NOT breathe the fumes. Prevent long contact with skin. Obey the manufacturer
warnings and cautions.
WARNING
Remove all power before you disassemble the unit.
WARNING
Professional installation is required. See Installation Control Document Installation 946-
0YE2-001D or later to properly install the unit in aircraft.
0YE2-001D or later to properly install the unit in aircraft.
CAUTION
To avoid damage to a unit, turn off the unit before you disconnect the unit from the
power source.
power source.
CAUTION
Electrostatic Discharge Sensitive (ESDS) devices. Normal clothing and floor coverings
make and hold a static charge. People that hold a low-energy static charge can damage
an ESDS device when they touch it. To prevent damage to ESDS devices, make sure that
the device and the surfaces that the device touches are grounded. Obey these
precautions:
• De-energize or remove all power, signal sources and loads.
• Put the unit on a grounded conductive surface.
• Ground the repair person with a conductive wrist strap or other device that
uses a 470K Ω or 1M Ω series resistor. The resistor limits current through the
make and hold a static charge. People that hold a low-energy static charge can damage
an ESDS device when they touch it. To prevent damage to ESDS devices, make sure that
the device and the surfaces that the device touches are grounded. Obey these
precautions:
• De-energize or remove all power, signal sources and loads.
• Put the unit on a grounded conductive surface.
• Ground the repair person with a conductive wrist strap or other device that
uses a 470K Ω or 1M Ω series resistor. The resistor limits current through the