Sony Corporation DTPT1000AB Manuel D’Utilisation
Preparing to use the unit
16
DTP-T2000A 4-121-350-11(1)
Connecting to a network with a DHCP
server
server
Connect the unit and a development PC running
the DHCP client software to a Hub/Switch on the
network.
the DHCP client software to a Hub/Switch on the
network.
In this case, the IP address and subnet mask
settings will be obtained automatically when the
unit is turned on. Depending on the settings of
the DHCP server, other network settings, such as
the DNS server and default gateway, may also be
obtained. For details on which settings can be
automatically obtained, contact your network
administrator.
settings will be obtained automatically when the
unit is turned on. Depending on the settings of
the DHCP server, other network settings, such as
the DNS server and default gateway, may also be
obtained. For details on which settings can be
automatically obtained, contact your network
administrator.
Connecting peripherals
1
Connect the unit to a Hub/Switch
using a network cable.
using a network cable.
2
Connect the Hub/Switch to the
development PC using a network
cable.
development PC using a network
cable.
Caution
When using the wireless LAN function, keep the controller
away from the unit’s aerial. If the unit is used with the
controller and aerial in close proximity, radio frequency
interference from the controller can affect the radio waves of
the wireless LAN.
away from the unit’s aerial. If the unit is used with the
controller and aerial in close proximity, radio frequency
interference from the controller can affect the radio waves of
the wireless LAN.
Hub/Switch
Controller
The unit
Development PCs
Monitor
Network
Connecting to a network
Connecting to a network
When using the unit in Europe,
Oceania and Korea
Oceania and Korea
Install the supplied RFI filter on the network
cable (unshielded twisted pair cable). Install the
RFI filter near the main unit.
cable (unshielded twisted pair cable). Install the
RFI filter near the main unit.
When installing the RFI filter on the cable, wind
the cable once around the RFI filter, as shown
below.
the cable once around the RFI filter, as shown
below.
There is a band supplied for use with the RFI
filter. Use the band to attach the RFI filter to the
cable. Fit the band to the cable, as shown below.
filter. Use the band to attach the RFI filter to the
cable. Fit the band to the cable, as shown below.
cable
RFI filter
Install near the unit
Cut after fitting
Band