Sony Corporation PCMD10 Manuel D’Utilisation
PCM-D10 4-744-528-11(1)
66
PCM-D10 4-744-528-11(1)
Changing the settings (continued)
Menu
Item
Settings (*: Default setting)
Recording
Settings
LIMITER
• When the setting is enabled, the peak value with the limiter circuit in
operation appears if the maximum peak value exceeds 0 dB.
• The recovery time represents the period when the linear PCM
recorder records sound at a volume 12 dB lower than the normal
circuit. In recordings where over-input occurs periodically, the
recording volume may be changed so frequently that it disturbs you.
If this occurs, try a longer recovery time setting.
circuit. In recordings where over-input occurs periodically, the
recording volume may be changed so frequently that it disturbs you.
If this occurs, try a longer recovery time setting.
Note
If a device is connected to the XLR/TRS jack(s), and if the left, right,
or both the left and right XLR/TRS INPUT LEVEL switch(es) are set to
the “LINE” position, the LIMITER function does not work.
or both the left and right XLR/TRS INPUT LEVEL switch(es) are set to
the “LINE” position, the LIMITER function does not work.
High S/N Mode
With two A/D converters for 1 channel, the linear PCM recorder
always reserves audio signals that are 12 dB lower than audio
processed in the normal circuit in addition to the normal audio
signals. If an over-input occurs, recorded data from the point at
which the over-input starts is replaced and compensated.
Replacement is executed while maintaining the linearity of two
A/D converters of different levels, realizing a high S/N ratio.
Noise can be suppressed even with a low recording level.
ON: The High S/N Mode function is enabled.
OFF*: The High S/N Mode function is disabled.
Note
While the LIMITER function is active, the High S/N Mode function is
disabled.
disabled.
PRE REC
You can buffer sound for approximately 5 seconds in the memory
when you press the
ĆREC button and the linear PCM recorder is
in standby for recording mode. When you press the
êREC PAUSE
(or the
à) button to start recording, recording actually starts 5
seconds prior to the point where the button is pressed.
ON:
The PRE REC (pre-recording) function is activated. When
you start recording, the recorder starts recording sound 5
seconds prior to the point where the button is pressed.
OFF*: The PRE REC (pre-recording) function is disabled. When
you start recording, recording starts at the point where
the button is pressed.
Plug In Power
When a plug-in power type microphone is connected to the
MIC IN/LINE IN jack on the linear PCM recorder, the linear PCM
recorder can supply power to the microphone. You can turn the
Plug In Power function on and off:
ON:
The linear PCM recorder supplies power to the connected
plug-in power type microphone.
OFF*: The linear PCM recorder does not supply power to the
connected plug-in power type jack.