International Business Machines Corporation 35H3636 Manuel D’Utilisation
If you plan to disconnect from your network, click the PC Card icon on the status
bar. A message box appears with a message to stop the PC Card. Click this box.
When the Safe to remove message appears, you can either remove the cable or
physically remove your PC Card.
bar. A message box appears with a message to stop the PC Card. Click this box.
When the Safe to remove message appears, you can either remove the cable or
physically remove your PC Card.
DOS ODI Hot-Pluggability and Suspend/Resume
It is recommended that you use the NetWare Event Service Layer program
(NESL.COM) for hot-plugging to work in this environment. Without this support, you
should use the following procedure.
(NESL.COM) for hot-plugging to work in this environment. Without this support, you
should use the following procedure.
To remove the card or go into a suspend mode, you must first unload all the
drivers. This is done by removing them in the reverse order they were installed.
This can be accomplished by typing the following commands at the DOS prompt:
drivers. This is done by removing them in the reverse order they were installed.
This can be accomplished by typing the following commands at the DOS prompt:
netx u
(or vlm u)
ipxodi u
tokencs u
lsl u
At this point, you can remove the card from your machine. Once the card is
removed, you can enter and exit suspend mode as often as you like before
reinstalling the card. It is best to reinstall the card while the machine is not in
suspend mode.
removed, you can enter and exit suspend mode as often as you like before
reinstalling the card. It is best to reinstall the card while the machine is not in
suspend mode.
After reinserting the card or resuming, you can restart your network software by
typing the following commands at the DOS prompt:
typing the following commands at the DOS prompt:
lsl
tokencs
ipxodi
netx
DOS NDIS Hot-Pluggability
You can insert and remove your card before and after using Windows for
Workgroups. You cannot hot-plug the card while using Windows for Workgroups.
Insert the card before starting the software. Remove the card only after exiting the
Windows for Workgroups environment.
Workgroups. You cannot hot-plug the card while using Windows for Workgroups.
Insert the card before starting the software. Remove the card only after exiting the
Windows for Workgroups environment.
OS/2 NDIS Hot-Pluggability and Suspend/Resume
You can remove the card or go into suspend mode at any time as long as you are
not running any applications that use shared resources. After you reinsert the card
or resume, you should have all of your LAN shared resources connected. If you use
CM/2 to connect to the host, you will have to log on again.
not running any applications that use shared resources. After you reinsert the card
or resume, you should have all of your LAN shared resources connected. If you use
CM/2 to connect to the host, you will have to log on again.
One scenario that does not work is suspending and then removing the card. The
card will not be recognized when it is reinserted. If you want to do something like
this, you must first remove the card and then suspend. You can then resume later
and reinsert the card later.
card will not be recognized when it is reinserted. If you want to do something like
this, you must first remove the card and then suspend. You can then resume later
and reinsert the card later.
8
Turbo 16/4 Token-Ring PC Card 2