Honeywell International Inc. 9PGTPA-100A Manuel D’Utilisation
MAINTENANCE MANUAL
CAS-100 COLLISION AVOIDANCE SYSTEM
Page 2096
1 Dec 2003
34-45-4
7
Use or disclosure of information on this page is subject to the restrictions in the proprietary notice of this document.
CAS-100 Interwiring Diagram
Figure 2015 (Sheet 6 of 16)
* In the above configurations, the traffic display is shown connected to the TA/RA Bus #1 output, in
this case the display status #3 input (RMP-7E) must be used. If a traffic display is connected to
the TA/RA Bus #2 output, then its display status output must be connected to the display status #4
input (RMP-7J).
Any unused traffic display status input pins must be grounded to prevent the unwanted failures
from being logged in the maintenance data output.
the TA/RA Bus #2 output, then its display status output must be connected to the display status #4
input (RMP-7J).
Any unused traffic display status input pins must be grounded to prevent the unwanted failures
from being logged in the maintenance data output.