Top Victory Electronics Co Ltd CM769D Manuel D’Utilisation

10

Problem & Question

Possible Solution

Power LED is not on

*Check if the Power Switch is in the ON

position

*Power Cord should be connected

No Plug & Play

*Check if the PC system is Plug & Play

compatible

*Check if the Video Card is Plug & Play

compatible

*Check if the D-15 plug pin of Video Cable

is bent

*Make sure the AOC Monitor Drivers are

installed
(AOC Monitor Drivers are available at:
www.aoc-europe.com)

No picture

*Computer Power Switch should be in the

ON position

*Computer Video Card should be snugly

seated in its slot

*The Signal Cable should be completely

connected to the computer

*Check the color of the Power LED

indicator. If it is orange, then the monitor
and the PC system are in power-saving
mode. You need press your keyboard or
move the mouse to reactivate the
system.

Picture is fuzzy

*Adjust the Contrast and Brightness

Controls.

Picture bounces or a wave
pattern is present in the picture

*Move electrical devices that may cause

electrical interference.

Monitor is stuck in “Power
Saving Mode”

*Make sure monitor’s video cable is

properly connected to the computer.

*Inspect monitor’s video cable and make

sure none of the pins are bent.

*Make sure computer is operational by

hitting the CAPS LOCK key on the
keyboard while observing the CAPS
LOCK LED.  The LED should either turn
ON or OFF after hitting the CAPS LOCK
key.

Missing one of the primary
colors (RED, GREEN, or
BLUE)

*Inspect the monitor’s video cable and

make sure that none of the pins are
bent.