RELM Communications Inc RPU416B Manuel D’Utilisation

OWNER’S MANUAL

RELM Wireless Corporation

Hold the antenna at its base, screw the antenna into the connector

on the top panel of the transceiver.

Position the edge of belt clip on the corresponding grooves on the

top of the battery pack. Push the belt clip along the back of the

battery pack until the release latch locks.

To remove the belt clip, pull back on the release latch located

between the battery pack and the belt clip, and slide the belt clip

away from the battery pack.

Remove the cover of the speaker/microphone jacks,then insert the

speaker/ microphone plugs into the speaker/microphone jacks.

The transceiver is not fully water resistant while using speaker/

microphone.

268ACManual.pm6

01-11-21, 11:06

9