HARRIS CORPORATION TR-386-A2 Manuel D’Utilisation
16
TRANSMITTING A BASIC CALL
1.
Make sure the radio is ON. Select the desired
system and channel as described in the previous
sections.
system and channel as described in the previous
sections.
2.
Observe the TX/RX indicator for any activity on the
channel. Never transmit with the green RX indicator
ON.
channel. Never transmit with the green RX indicator
ON.
3.
Press and hold the
EMER
button for at least l second
to Monitor the channel for activity. Noise will be
heard if there is no activity on the channel. This will
also help in setting the volume level to the desired
level.
heard if there is no activity on the channel. This will
also help in setting the volume level to the desired
level.
4.
Remove the microphone from the hookswitch.
Holding the microphone approximately 2 inches
from your mouth, press the PTT button on the side of
the microphone and speak in the microphone.
Holding the microphone approximately 2 inches
from your mouth, press the PTT button on the side of
the microphone and speak in the microphone.
?
Always speak in a normal tone of voice. Hold the microphone
cupped in your hand and approximately three (3) inches from
your mouth. Shouting will degrade your transmission, so do
not speak any louder than normal.
cupped in your hand and approximately three (3) inches from
your mouth. Shouting will degrade your transmission, so do
not speak any louder than normal.
5.
When you have finished speaking, release the PTT
button and wait for a reply.
button and wait for a reply.
CHANNEL GUARD
Channel Guard is a method of reducing "channel chatter" by equipping
receivers with a device that only allows calls with the correct signaling
to be heard by the user. Channel Guard is defined in the radio
personality.
receivers with a device that only allows calls with the correct signaling
to be heard by the user. Channel Guard is defined in the radio
personality.
To Disable Channel Guard (Decode):
If Channel Guard is ON, the CG status indicator will be ON.