Canon FM33490 Manuel D’Utilisation

  

1/1   

 

 

Note: This equipment has been tested and found to comply with the limits for a Class A digital 

device, pursuant to Part 15 of the FCC Rules, and the limits for an ISM equipment, pursuant to 

Part 18 of the FCC Rules. These limits are designed to provide reasonable protection against 

harmful interference when the equipment is operated in a commercial environment. This 

equipment generates, uses, and can radiate, radio frequency energy and, if not installed and 

used in accordance with the Operator's Manual, may cause harmful interference to radio 

communications. 

Operation of this equipment in a residential area is likely to cause harmful interference in which 

case the user will be required to correct the interference at his own expense. 

Use of shielded cables are required to comply with Class A limits in Subpart B of Part 15 of the 

FCC Rules. 

Do not make any changes or modifications to the equipment unless otherwise specified in the 

manual. If you make such changes or modifications, you could be required to stop operation of 

the equipment. 

If your equipment malfunctions, please contact your local authorized Canon dealer from whom 

you purchased the equipment (if under warranty), or with whom you have a servicing contract. If 

you are not sure who to contact, and have both purchased and are using the equipment in the 

U.S.A., please refer to the "SUPPORT" page on Canon U.S.A.'s Web site 

(http://www.usa.canon.com). 

 

This transmitter must not be co-located or operated in conjunction with any other antenna or 

transmitter. 

This device complies with Part 15 of FCC Rules and RSS-Gen of IC Rules.    Operation is 

subject to the following two conditions: (1) this device may not cause interference, and (2) 

this device must accept any interference, including interference that may cause undesired 

operation of this device.   

This equipment complies with FCC/IC radiation exposure limits set forth for uncontrolled 

equipment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C 

to OET65 and RSS-102 of the IC radio frequency (RF) Exposure rules.    This equipment 

should be installed and operated with at least 20cm and more between the radiator and 

person’s body (excluding extremities: hands, wrists, feet and ankles).