UTC Fire & Security Americas Corporation Inc 855-NODE Manuel D’Utilisation
3
QuikBridge Node repeater Installation Instructions
Off
No Activity
00
Short Blink
On
Repeater received a packet from an enrolled sensor
01
Off
No Activity
01
Long Blink
On
Repeater received an enrollment-type packet from an
enrolled sensor and has deleted that sensor from
memory.
10
Off
No Activity
10
Long Blink
On
Repeater received an enrollment-type packet from an
unenrolled sensor and has enrolled that sensor into
memory.
11
Constant
Blinking
DIP switches are set to “delete all” mode, but repeater
is awaiting a press and release of the tamper switch
before it does the deletion.
11
Long Blink
On
Repeater has detected a press and release of the tamper
switch and deleted all sensors from memory
Installation
Overview
Overview
There are two basic installation methods, depending on whether the enrollment of sensors is
to be done using a personal computer (PC) or the DIP switches. Note that a PC is required for
initial configuration regardless of the method of sensor enrollment. The following are the
basic steps of each method. The steps are described more fully in later sections.
to be done using a personal computer (PC) or the DIP switches. Note that a PC is required for
initial configuration regardless of the method of sensor enrollment. The following are the
basic steps of each method. The steps are described more fully in later sections.
Installation using a PC
1. Mount the repeater board in the enclosure.