Bosch Security Systems Inc. M532 Manuel D’Utilisation
BTR-240 Users Manual - Preliminary
Page 3 of 8
Rev D – 4 / 18 / 2011
Controls and Connections (cont.)
Figure 2
BTR-240 – Rear Panel
1. Transmit Antenna – reverse “TNC” connector.
2. Program Input – this RJ-45 jack is used for
2. Program Input – this RJ-45 jack is used for
wired Ethernet connections, configuration, and to
update programming in the unit if ever needed.
update programming in the unit if ever needed.
3. Receive Antenna – reverse “TNC” connector.
4. Speaker Output – one 2-pin connector to attach
cables and a speaker (1W
rms
max into 8Ohms).
5. Intercom Channel 1 Input / Output – Interface
to wired intercom system 1.
2-Wire – male and female 3-pin XLR
connectors wired in parallel. The
connectors are switched to the appropriate
intercom configuration via the menu
options.
4-Wire – an RJ-11jack compatible with
“Matrix” type intercom systems.
connectors wired in parallel. The
connectors are switched to the appropriate
intercom configuration via the menu
options.
4-Wire – an RJ-11jack compatible with
“Matrix” type intercom systems.
6. Intercom Channel 2 Input / Output – Interface
to wired intercom system 2.
2-Wire – male and female 3-pin XLR
connectors wired in parallel. The
connectors are switched to the appropriate
intercom configuration via the menu
options.
4-Wire – an RJ-11jack compatible with
“Matrix” type intercom systems.
connectors wired in parallel. The
connectors are switched to the appropriate
intercom configuration via the menu
options.
4-Wire – an RJ-11jack compatible with
“Matrix” type intercom systems.
7. Auxiliary Input / Output – One 3-pin female
XLR / ¼ inch combination input connector and
one 3-pin male XLR output connector.
one 3-pin male XLR output connector.
8. DC Input Jack – Accepts 12-15 VDC, 2.0
Amps to power the base station from a D.C.
source.
source.
9. Chassis Ground –grounding point of the base
station.
1 2
3
4
5
8
7
6
9