Southern Avionics Company SD50 Manuel D’Utilisation
SD SERIES TRANSMITTER
47
•
•
•
•
•
•
Southern Avionics Company
SECTION 2
2.2.4 Controller / Monitor PCB
SLP10007 – Controller / Monitor
The CONTROLLER/ MONITOR employs the new Motorola MCF5206 COLDFIRE®
microprocessor. It encompasses the following sections:
microprocessor. It encompasses the following sections:
1. COLDFIRE Processor – 32-bit
2. ADC – 8-Channel 12-bit
3. DAC – 8-Channel 8-bit
4. DDS - Radio Frequency (190K to 1800KHz)
5. DDS – Tone Frequency (400 / 1020 Hz)
6. Flash Memory – 4Mb
7. DRAM – 16Mb
8. Programmable Logic
9. Digital I/O (Read/Write)
10. UART
11. Watch Timer and NV-RAM
2. ADC – 8-Channel 12-bit
3. DAC – 8-Channel 8-bit
4. DDS - Radio Frequency (190K to 1800KHz)
5. DDS – Tone Frequency (400 / 1020 Hz)
6. Flash Memory – 4Mb
7. DRAM – 16Mb
8. Programmable Logic
9. Digital I/O (Read/Write)
10. UART
11. Watch Timer and NV-RAM
²
COLDFIRE Processor section:
The LOGIC program creates 16MHz from 32MHz for the clock frequency of the
microprocessor. The processor controls several peripheral functions such as memory,
task timers, I/O bus lines, and RS-232 ports. For the dual system, the primary
Controller / Monitor and secondary Controller / Monitor may talk to each other
through Controller / Monitor Motherboard (SLP10012) by using 2 COM-PORT lines
(ex: RXD & TXD). Each Controller / Monitor has one interrupt line for paying
attention what other Controller / Monitor has something is important, then Controller /
Monitor sets “RS-232” MUX to be enabled.
microprocessor. The processor controls several peripheral functions such as memory,
task timers, I/O bus lines, and RS-232 ports. For the dual system, the primary
Controller / Monitor and secondary Controller / Monitor may talk to each other
through Controller / Monitor Motherboard (SLP10012) by using 2 COM-PORT lines
(ex: RXD & TXD). Each Controller / Monitor has one interrupt line for paying
attention what other Controller / Monitor has something is important, then Controller /
Monitor sets “RS-232” MUX to be enabled.
²
Analog-to-Digital converter (ADC) section:
The Controller / Monitor Controller PCB has two (AD7891) 12-bit ADC chips, so
there are 16 analog inputs. The channel selection of input range is 0 to +5 V.
there are 16 analog inputs. The channel selection of input range is 0 to +5 V.
²
Digital-to-Analog Converter (DAC) section:
The 8-bit DAC provides eight digitally controlled dc voltage outputs. The limited of
output range is 0 to +5 V. The user may adjust dc analog level or turn on/off likely
digital level.
output range is 0 to +5 V. The user may adjust dc analog level or turn on/off likely
digital level.
²
RF Direct Digital Synthesizer (DDS) section:
The 50MHz clock input is for the RF DDS. The RF DDS provides two different
signal-waves (square wave and sine wave). The square wave level is 0 to +5.0 V
(recommended) and the sine wave level is 0 to 1.0 V. The DDS has 8 data digitally
signal-waves (square wave and sine wave). The square wave level is 0 to +5.0 V
(recommended) and the sine wave level is 0 to 1.0 V. The DDS has 8 data digitally