Andrew Wireless Innovations Group RPT-MOR801 Manuel D’Utilisation
User’s manual for Remote Unit MOR801B Power
M0070A0A.doc
Id.-No 151155
Page 66
18-June-99
The power supply is fixed to the Repeater housing by means of two special nuts M4. After
loosening the screws the power supply can be removed. To open these screws a special key
with a spherical head is required (This key is part of the delivery). Place a small screwdriver
between the Repeater housing and the power supply to loose the device.
loosening the screws the power supply can be removed. To open these screws a special key
with a spherical head is required (This key is part of the delivery). Place a small screwdriver
between the Repeater housing and the power supply to loose the device.
figure 9-13 Position of special-nut M4
Note:
Don’t forget to put heat conducting paste on the mounting side for
installation of a new power supply. Use the conducting paste, which is
included in the spare parts kit.
installation of a new power supply. Use the conducting paste, which is
included in the spare parts kit.
9.11 Replacement of Active Combiner modules
The Active Combiner modules are mounted on both sides of the Repeater.
Disconnect all SMA connectors by means of a torque wrench.
Unscrew two counter sunk screws M3x20mm. See figure 9-14 Position of counter sunk
screws on Active Combiner.
screws on Active Combiner.