Andrew Wireless Innovations Group 9GB2000 Manuel D’Utilisation

aware that some terminal emulation programs generate extraneous characters
that may interfere with communicating with the EAC-2000.

3. 

Power up the EAC-2000.  (After about 2 seconds, the terminal should respond
 CONSOLE LOCKED.)

4. 

Enter <CR> (carriage return or enter, depending on the keyboard).  (The

•

If something comes up but is illegible, check the terminal setup.

•

  If nothing comes up, power down.  Recheck the power hookup, the

terminal hookup, and the terminal setup.

5. 

Enter the password, followed by <CR>.  The default password is 1234.  (The
terminal should respond with more salutation and the > prompt.)  The system
is ready for you to set parameters.

Configuring the system consists of re-entering previous analog channel and setup
information as well as the new digital setup parameters into the IS-136 Controller.
To make this operation easier, the setup screens exactly parallel those used in the
AMPS EAC-2000, with additions to cover digital operation as needed. Since for
many systems the default values are acceptable, reprogramming of those values will
not be needed.  The defaults for both the AMPS and digital-equipped EAC-2000 are
shown on the Parameter Worksheet.

The following changes have been made to the SET menus to accommodate DCCH
and DTC operation:

1) In the RF Boards / Position X menu, STATUS parameter, the following choices

are now available (for all boards except board 6):

        

(0) DISABLED

     (1) ENABLED AMPS Control
     (2) ENABLED AMPS Voice
     (3) ENABLED TDMA DCCH
     (4) ENABLED TDMA DTC

For board 6, the choices are:

(0)

  DISABLED

(1) ENABLED Scan