Zoom Telephonics Inc 1058WL Manuel D’Utilisation
Chapter 1: Installation Instructions
15
c
Depending on the Protocol setting you selected the
bottom half of the page will change so that you can enter
additional information.
bottom half of the page will change so that you can enter
additional information.
If you selected PPPoA or PPPoE, enter your ADSL
Username and Password in the appropriate boxes.
Your Internet service provider should have given this
information to you. (Your Username is typically your
email address or the characters preceding the @ sign
in your email address. This is NOT the same
Username and Password that you used earlier to open
the Zoom Configuration Manager.)
Your Internet service provider should have given this
information to you. (Your Username is typically your
email address or the characters preceding the @ sign
in your email address. This is NOT the same
Username and Password that you used earlier to open
the Zoom Configuration Manager.)
If you selected 1483 Bridged or 1483 Routed, you
have the option of using either dynamic or static IP
addressing. Depending on your situation, select the
appropriate option button:
− [MOST USERS] Ensure that Obtain an IP
addressing. Depending on your situation, select the
appropriate option button:
− [MOST USERS] Ensure that Obtain an IP
address Automatically is selected if you are
using Dynamic Host Configuration Protocol (also
known as DHCP or dynamic IP addressing). This
option is selected by default because most Internet
service providers use DHCP.
using Dynamic Host Configuration Protocol (also
known as DHCP or dynamic IP addressing). This
option is selected by default because most Internet
service providers use DHCP.
− Select Use the following IP Address only if you
are using a static IP address. (You should know if
you are using static IP addressing. There is
typically an extra charge for a static IP address and
you usually have to make special arrangements
with your Internet service provider to get one.)
Then enter the IP Address, Subnet Mask,
Default Gateway, and DNS that you plan to use.
Click the Save Changes button, then click the
Write Settings to Flash button.
you are using static IP addressing. There is
typically an extra charge for a static IP address and
you usually have to make special arrangements
with your Internet service provider to get one.)
Then enter the IP Address, Subnet Mask,
Default Gateway, and DNS that you plan to use.
Click the Save Changes button, then click the
Write Settings to Flash button.