Tae Kwang Industrial Co Ltd GMRS310 Manuel D’Utilisation
- 8 -
- Desire Before ask repair, to inquire to A/S center in case of is not solved after inspect following item.
Sympt oms upper
Point sword four clauses
Power supply is not lighted.
1. Confirm whether battery is discharged.
2. Confirm whether new battery and old battery mix.
3. Confirm whether battery polarity is threaded wrongly.
2. Confirm whether new battery and old battery mix.
3. Confirm whether battery polarity is threaded wrongly.
Tone is not said.
1 . Confirm whether volume is established by smallest
Tone is not clean.
1. Confirm whether battery is discharged.
2. Is not very far away with other person?
2. Is not very far away with other person?
BEEP sound is not said.
1 . Confirm whether is by BEEP sound OFF (cancellation) mode.
Power has turned off constantly.
1 . Confi rm whether battery discharged.
Currency distance is short.
1. Hand or outside microphone etc . Confirm touches in antenna.
2 . Confirm whether transmission of a message output is established by
2 . Confirm whether transmission of a message output is established by
LOW mode.
When receive, "BUSY" twinkles
and it does not become reception.
and it does not become reception.
1 . Confirm whether other person and ton code conform.
Transmission of a message acts
continually.
continually.
1 . Confirm whether VOX SEN LEVEL is established so low.
VOX do not act.
1 . Confirm VOX SEN LEVEL whether this so high establish.
Is brok en Transmission of a
message of VOX action every
time.
message of VOX action every
time.
1. Confirm whether VOX SEN LEVEL is established so high.
2. Confirm VOX DELAY TIME is established so shortly.
2. Confirm VOX DELAY TIME is established so shortly.
Is not Reception becomes
Sometimes to On call.
Sometimes to On call.
1. Is not very far away with other person?
2. Confirm whether transmission of a message output is established by
2. Confirm whether transmission of a message output is established by
LOW mode.
Charger (Limitation box to person
which buy addition) LED is not
lighted.
which buy addition) LED is not
lighted.
1. Confirm whether terminal is raised properly.
2. Confirm whether adaptor is linked properly.
2. Confirm whether adaptor is linked properly.
9. Standard.