Mitsubishi Electric Corp HS-HD2000U Manuel D’Utilisation

14

Tapes can be loaded into your VCR as long as the VCR is plugged in.  Even when
the VCR POWER is off, loading a tape will automatically turn the VCR on.  Use
only tapes that have a 

, 

 or 

 label.

Hold the tape so that the long narrow edge with the contents label faces you.
The other edge is hinged and should face the VCR.  The plastic window that
shows the videotape should face up.

Gently insert the tape evenly into the cassette slot until the VCR automatically
takes it in.

If the VCR will not automatically take the tape in, press EJECT and try again.

Your VCR will eject the tape if it is loaded improperly.  If the VCR ejects the tape;
remove the tape, check to see that the contents label is facing you, that the geared
tape reels are facing down, wait a few seconds, and try again.

When you are connecting the integrated HDTV or IEEE 1394-equipped HDTV
receiver which is available to control the VCR:
Operate your TV or receiver to playback the tape.  Refer to the TV or receiver
owner’s guide for this procedure.

When you are connecting the integrated HDTV or IEEE 1394-equipped HDTV
receiver which is not available to control the VCR:
Press PLAY on the front panel or the remote control of the VCR.

You can stop playing by pressing STOP.

It will take a few seconds to display the playback picture.  The mosaic noise, still or
black picture will appear until the correct picture appears.

When you playback the end point of a recording, the point where the recording
mode changes or the broken part of the tape, the mosaic noise, still or black picture
may appear.

The tape recorded in D-VHS format by another VCR may not be played back
correctly on this VCR.

Press PLAY on the front panel or the remote control.

The VCR will automatically play the tape at the correct speed.  When the VCR
reaches the end of the tape, it will automatically rewind to the beginning of the tape
and stop.

You can stop playing by pressing STOP.

CORRECT

INCORRECT