Eccel Technology Ltd BIORADRDR0200 Manuel D’Utilisation
69
8.5.3 Labelling
[R8-1] The board after mounting components shall be delivered with an Identification Label which contains following
information, all in capital letters (Picture 5-5):
information, all in capital letters (Picture 5-5):
• The name ‘BIORAD RFID READER V2.0.16’ in the first line.
• The FCC ID in the second line.
• The IC number in the third line
• The Serial Number in the fourth line.
• The manufacturing date in the fifth line formatted as ‘YYYY/MM/DD’.
• The data matrix code at the end containing all the above information.
• The FCC ID in the second line.
• The IC number in the third line
• The Serial Number in the fourth line.
• The manufacturing date in the fifth line formatted as ‘YYYY/MM/DD’.
• The data matrix code at the end containing all the above information.
[R8-2] The Serial Number shall be formatted as a six-digit number starting from 000001.
[R8-3] The Identification Label shall be 30 mm high and 26 mm wide.
[R8-4] The board after mounting components shall be delivered with Control Label containing four same boxes with
a letter printed in ARIAL 12 BOLD font:
a letter printed in ARIAL 12 BOLD font:
• ‘V’ for manual visual inspection.
• ‘A’ for Automate Optical Inspection (AOI).
• ‘F’ for functional testing and control.
• ‘P’ for programming of all programmable components of the board per programming specification.
• ‘A’ for Automate Optical Inspection (AOI).
• ‘F’ for functional testing and control.
• ‘P’ for programming of all programmable components of the board per programming specification.
[R8-5] Control Label shall be 10 mm in height and 15 mm in width.
[R8-6] Control boxes on the Control Label shall be ticked (marked) during the manufacturing control procedure with
a permanent (indelible) pen.
a permanent (indelible) pen.
[R8-7] If the manufactured devices pass manual visual inspection, then the ‘V’ control box on the Control Label shall
be ticked (marked) in a visible way.
be ticked (marked) in a visible way.
[R8-8] If the manufactured device passes functional testing, then the ‘F’ control box on the Control Label shall be
ticked (marked) in a visible way.
ticked (marked) in a visible way.
[R8-9] After manufactured devices are programmed with the appropriate firmware, the ‘P’ control box on the
Control Label shall be ticked (marked) in a visible way.
Control Label shall be ticked (marked) in a visible way.
[R8-10] When a manufactured device has passed AOI, the ‘A’ control box on the Control Label shall be ticked
(marked) in a visible way.
(marked) in a visible way.
[R8-11] Labels shall be placed as shown in Picture 8-6 where space inside rectangle number one is designated for the
Identification Label and space inside rectangle number two is designated for the Control Label.
Identification Label and space inside rectangle number two is designated for the Control Label.