TeVii Technology Co. Ltd. G201TX Manuel D’Utilisation
13
If still not solved problems, pls power off to re-start the Wireless HDMI Sender and receiver.
4.Picture is not stable, or picture is stuck.
this device is using 2.4GHz connectivity, which will interfere by other wireless devices, like wifi
router, microwave, so pls keep the TX/RX away from those interferences. This distance between
TX/RX can be about 200-300 M in good wifi condition and no wall, if wifi environment is not good,
the distance will be much shorter. pls also place the TX/RX at other location with less interference.
Unplug the power cable of TX/RX and restart it.
router, microwave, so pls keep the TX/RX away from those interferences. This distance between
TX/RX can be about 200-300 M in good wifi condition and no wall, if wifi environment is not good,
the distance will be much shorter. pls also place the TX/RX at other location with less interference.
Unplug the power cable of TX/RX and restart it.
Also the distance between TX and RX should be at least 1 meter to decrease the interference.
5. why I can’t control the device in different room by using the remote control?
pls use the original remote control of the source device.
Pls stick the IR emitter probe in the surface
of IR LED place of the source device
of IR LED place of the source device
pls point the remote control to the IR receiver probe within 5m in directly.
Chapter 4
Safety and Emission Statement
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.