Robert Bosch Security Solutions Pte Ltd SE-TRM-433T01 Manuel D’Utilisation
14
en | Basic Transmitter Features
Security Escort Personnel Transmitter
2017.08 | SE3v1.0 | DL
Installation Manual
Robert Bosch (SEA) Pte Ltd
6
Basic Transmitter Features
This section provides information of the various features of the transmitter.
6.1
Features for Transmitter Profiles
The table below lists the various transmitter profiles and their features:
Features
Transmitter Profiles
User
Maintenance
Security
Man-down
x
x
x
Supervision Tracking (Silent)
x
x
x
Auto-tracking
x
x
Lanyard Snatch Alarm
x
Lanyard Snatch Alarm (Silent)
x
Manual Alarm
x
x
Manual Alarm (Silent)
x
By default, all features emit a series of mixed tones unless otherwise stated as silent.
6.2
Transmitting a Manual Alarm
Initiate an alarm by pressing and holding the Alarm button for 1 second.
This emits a series of mixed tones for 2 seconds and sends an alarm signal to the Central
Console. If alarm is activated within sight of a receiver, the red LED on the receiver lights up.
After initiating a manual alarm, the Auto-tracking feature sends your latest location to the
Central Console every 7 seconds (configurable).
Reset the transmitter after a manual alarm by performing a test mode as described in Testing
the Transmitter, page 13.
This emits a series of mixed tones for 2 seconds and sends an alarm signal to the Central
Console. If alarm is activated within sight of a receiver, the red LED on the receiver lights up.
After initiating a manual alarm, the Auto-tracking feature sends your latest location to the
Central Console every 7 seconds (configurable).
Reset the transmitter after a manual alarm by performing a test mode as described in Testing
the Transmitter, page 13.
6.3
Man-down Alarm
Whenever you are in a prone position (60° from upright) for more than 5 seconds
(configurable), the transmitter sends an alarm signal. There is no alarm signal if transmitter is
restored within 5 seconds.
If alarm is activated within sight of a receiver, the red LED lights up.
Reset the transmitter after a Man-down Alarm by returning the transmitter to the upright
position and performing a test mode.
(configurable), the transmitter sends an alarm signal. There is no alarm signal if transmitter is
restored within 5 seconds.
If alarm is activated within sight of a receiver, the red LED lights up.
Reset the transmitter after a Man-down Alarm by returning the transmitter to the upright
position and performing a test mode.
6.4
Lanyard Snatch Alarm
Initiate an alarm by pulling the lanyard off the transmitter.
This emits a series of mixed tones for 2 seconds, followed by short beeps at 250 millisecond
intervals. The transmitter sends an alarm signal to the Central Console. If activated within
sight of a receiver, the red LED of the receiver lights up.
To reset the transmitter after a Lanyard Snatch Alarm, reinsert the lanyard pin and perform a
test mode.
This emits a series of mixed tones for 2 seconds, followed by short beeps at 250 millisecond
intervals. The transmitter sends an alarm signal to the Central Console. If activated within
sight of a receiver, the red LED of the receiver lights up.
To reset the transmitter after a Lanyard Snatch Alarm, reinsert the lanyard pin and perform a
test mode.
6.5
Auto-tracking
The Auto-tracking feature sends the latest location to the Central Console every 7 seconds
(configurable) after an alarm is triggered.
(configurable) after an alarm is triggered.