Robert Bosch Security Solutions Pte Ltd SE-TRM-433T01 Manuel D’Utilisation
Security Escort Personnel Transmitter
Installation and Setup | en
9
Robert Bosch (SEA) Pte Ltd
Installation Manual
2017.08 | SE3v1.0 | DL
4
Installation and Setup
This section provides information for system planners and configurators.
4.1
Removing the Cover
Figure 4.1: Back of Transmitter
1 Retaining Screw
2 Lower Part
Instructions
1.
1.
Remove the belt clip, if used.
2.
Remove the retaining screw on the back of the enclosure.
3.
Use a flat-head screwdriver to pry the lower part of the front cover away from the
enclosure.
enclosure.
4.2
Battery
The transmitter uses a CR2 3 V lithium battery. The Central Console indicates when the
battery is low and needs replacement. Refer to Enabling and Disabling Features, page 10 for
battery polarity. The battery’s life depends on usage and enabled features.
battery is low and needs replacement. Refer to Enabling and Disabling Features, page 10 for
battery polarity. The battery’s life depends on usage and enabled features.
!
Caution!
Replacement of the battery with an incorrect type is subject to the risk of explosion. Batteries
must not be disposed of in household waste to avoid the risk of explosion.
Replacement of the battery with an incorrect type is subject to the risk of explosion. Batteries
must not be disposed of in household waste to avoid the risk of explosion.