Robert Bosch Security Solutions Pte Ltd SEC-3402-304 Manuel D’Utilisation
Security Escort Point Tracking Transmitter
Enabling and Disabling Features | en
17
Robert Bosch (SEA) Pte Ltd
Installation Manual
2017.11 | SE3v1.0 | DL
1 ID number
4.9
Configuring the transmitter
Notice!
Please note that this feature is only applicable to SEC-3402-433 transmitter model!
Please note that this feature is only applicable to SEC-3402-433 transmitter model!
All factory reset features can be configured wirelessly on the transmitter via the coordinator/
receiver using the Central Console software. Enroll transmitter to the Central Console
software before configuration. Using the Central Console software, enable or disable the
features accordingly and send the configuration to the transmitter. Please refer to the Security
Escort Technical Reference Manual for further details.
receiver using the Central Console software. Enroll transmitter to the Central Console
software before configuration. Using the Central Console software, enable or disable the
features accordingly and send the configuration to the transmitter. Please refer to the Security
Escort Technical Reference Manual for further details.
4.10
Testing the transmitter
Test your transmitter by standing within sight of a receiver. Press the Test button for 3
seconds until the transmitter emits 3 short beep tones. A test transmission is sent to the
Central Console, lighting the green LED on a receiver or the strobe on an outdoor siren-strobe.
There might be a brief delay of 2 to 3 seconds before the flashing light appears. A successful
test transmission will light up the green LED on a receiver; retest if otherwise.
seconds until the transmitter emits 3 short beep tones. A test transmission is sent to the
Central Console, lighting the green LED on a receiver or the strobe on an outdoor siren-strobe.
There might be a brief delay of 2 to 3 seconds before the flashing light appears. A successful
test transmission will light up the green LED on a receiver; retest if otherwise.