Robert Bosch Security Solutions Pte Ltd SEC-3402-304 Manuel D’Utilisation
Security Escort Point Tracking Transmitter
System Overview | en
7
Robert Bosch (SEA) Pte Ltd
Installation Manual
2017.11 | SE3v1.0 | DL
2
System Overview
The SEC-3402 series point transmitter is a magnetic and dry contact wireless transmitter used
for monitoring assets.
The unit is equipped with an internal reed contact for use with an external magnet assembly
(included), a cover tamper switch, a displacement detector, a buzzer and RF supervision. The
SEC-3402 series can accept a supervised dry contact input from an external device.
The transmitter is available in the following models:
for monitoring assets.
The unit is equipped with an internal reed contact for use with an external magnet assembly
(included), a cover tamper switch, a displacement detector, a buzzer and RF supervision. The
SEC-3402 series can accept a supervised dry contact input from an external device.
The transmitter is available in the following models:
Transmitter Model
Description
SEC-3402-304
Point tracking transmitter, 303/304MHz
SEC-3402-433
Point tracking transmitter, 433MHz
2.1
Supervision
Supervision is provided by transmitting a low power level signal to the receiver every 60 min if
there is no other activity. SEC-3402 series send battery status information to the system.
there is no other activity. SEC-3402 series send battery status information to the system.
2.2
Auto-tracking
Once an alarm is initiated, such as the transmitter moved away from the magnet, the auto
tracking feature begins. The transmitter sends a signal back to the central console every 7
seconds, updating its location for 15 minutes. To reset the transmitter after an alarm has been
initiated, all device conditions (such as tamper, loop, or magnet) must be reset to normal.
tracking feature begins. The transmitter sends a signal back to the central console every 7
seconds, updating its location for 15 minutes. To reset the transmitter after an alarm has been
initiated, all device conditions (such as tamper, loop, or magnet) must be reset to normal.