Clarinox Technologies Pty Ltd 1531 Manuel D’Utilisation
KM-153103 Datasheet
Page 5
Module Certification Details
KM-153103 Koala® Connect module complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
the following two conditions:
(1) This device may not cause harmful interference and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Clarinox Technologies declares that the radio equipment type RF module is in compliance with
Directive 2014/53/EU.
Directive 2014/53/EU.
The compliance has been verified in the operating frequency band of 2400-2483.5 MHz. Developers
and integrators that incorporate the KM-153103 Module in any end products are responsible for
obtaining applicable regulatory approvals for such end product.
and integrators that incorporate the KM-153103 Module in any end products are responsible for
obtaining applicable regulatory approvals for such end product.
The KM-153103 has been tested in the 2400 MHz-2483.5 MHz ISM frequency band at 3.3 V with a
maximum peak power of 19.7 dBm EIRP across the temperature range –40°C to +85°C and tolerance.
maximum peak power of 19.7 dBm EIRP across the temperature range –40°C to +85°C and tolerance.
1.2.1.1 Federal Communications Commission (FCC) Statement
This module complies with FCC radiation exposure limits set forth for an uncontrolled environment.
End users must follow the specific operating instructions for satisfying RF exposure limits. This
transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
End users must follow the specific operating instructions for satisfying RF exposure limits. This
transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
1.2.1.2 End Product Labelling
This module is designed to comply with the FCC statement, FCC ID: 2AN5P1531. The host system
using this module must display a visible label indicating the following text:
using this module must display a visible label indicating the following text:
"Contains FCC ID: 2AN5P1531"
Important Notice to OEM Integrators
This module is limited to OEM installation ONLY.
This module is limited to installation in mobile or fixed applications, according to FCC Part 2.1091(b).
The separate approval is required for all other operating configurations, including portable
configurations with respect to FCC Part 2.1093 and different antenna configurations
configurations with respect to FCC Part 2.1093 and different antenna configurations
For FCC Part 15.31 (h) and (k): The host manufacturer is responsible for additional testing to verify
compliance as a composite system. When testing the host device for compliance with Part 15
Subpart B, the host manufacturer is required to show compliance with Part 15 Subpart B while the
transmitter module(s) are installed and operating. The modules should be transmitting and the
evaluation should confirm that the module's intentional emissions are compliant (i.e. fundamental
and out of band emissions). The host manufacturer must verify that there are no additional
unintentional emissions other than what is permitted in Part 15 Subpart B or emissions are
complaint with the transmitter(s) rule(s).
compliance as a composite system. When testing the host device for compliance with Part 15
Subpart B, the host manufacturer is required to show compliance with Part 15 Subpart B while the
transmitter module(s) are installed and operating. The modules should be transmitting and the
evaluation should confirm that the module's intentional emissions are compliant (i.e. fundamental
and out of band emissions). The host manufacturer must verify that there are no additional
unintentional emissions other than what is permitted in Part 15 Subpart B or emissions are
complaint with the transmitter(s) rule(s).