RosimITS Tech.CO. Ltd. WVD Manuel D’Utilisation
User Manual: Wireless Vehicle Detector
9 / 9
Step 6: Embedding
There’s a triangle mark, which indicates the traffic
flow direction, on one of the arris around the side of
WVD. The triangle mark should point to the vehicle
movement direction when installation.
After the filling is ready, find the triangle mark from
the arris around the side of WVD and point it to the
traffic flow movement direction, then put the WVD in
the hole quickly and keep the top of the WVD equal
to or 3-5mm lower than the surface of the road. It is
important to clean up the sensor from the overflows.
flow direction, on one of the arris around the side of
WVD. The triangle mark should point to the vehicle
movement direction when installation.
After the filling is ready, find the triangle mark from
the arris around the side of WVD and point it to the
traffic flow movement direction, then put the WVD in
the hole quickly and keep the top of the WVD equal
to or 3-5mm lower than the surface of the road. It is
important to clean up the sensor from the overflows.
Step 7: Check
After installation of all the sensors, it is
recommended to check all sensors’ online status in
cooperate with the Wireless Access Point (WAP).
The ID of each sensor is corresponding to one of the
48 LEDs on the front panel of WAP. The relationship
between detection results and LED status is:
LED=Red---------------------Vehicle detected
LED=Green------------------No vehicle
LED=Green flash-----------WVD warning
LED=Off----------------------No WVD installed in this lane
LED=Red but no vehicle---WVD is in auto calibrating
Note that the status of those un-used LEDs might be
uncertain and should be ignored, since there is no
WVD sensor is bounded to them.
recommended to check all sensors’ online status in
cooperate with the Wireless Access Point (WAP).
The ID of each sensor is corresponding to one of the
48 LEDs on the front panel of WAP. The relationship
between detection results and LED status is:
LED=Red---------------------Vehicle detected
LED=Green------------------No vehicle
LED=Green flash-----------WVD warning
LED=Off----------------------No WVD installed in this lane
LED=Red but no vehicle---WVD is in auto calibrating
Note that the status of those un-used LEDs might be
uncertain and should be ignored, since there is no
WVD sensor is bounded to them.
7. Supports
ROSIM creates and manufactures high quality wireless parking detection devices. We
provide customers 24 hours on-line supports.
provide customers 24 hours on-line supports.
Rosim ITS Technology Co., Ltd.
Tel: +86-760-85313186
Mob: +86 13924057168
Fax: +86-769-85313186
E-Mail: Rosimits@163.com
Site:
Tel: +86-760-85313186
Mob: +86 13924057168
Fax: +86-769-85313186
E-Mail: Rosimits@163.com
Site: