SHENZHEN BAIJUNDA ELECTRONIC CO. LTD WD-282-010Q Manuel D’Utilisation
Type: Car Mount Wireless Charger
Model No. : WD-282-010Q
Material: PC(Fireproof)
Size: 100*135*96.5 mm
Input: DC 5V 2A; 9V 1.67A
Circuit protections: high temperature,
over-current,over-voltage
and short circuit;
Model No.: WD-282-010Q
Specifications:
Features:
Cautions:
Structure Diagram:
Phone and wireless charger base matching diagram
Welcome
to use BJD wireless charger. It is suitable for office/home/travel and other
occasions
, with newly charging experience.
Usage:
Car Mount Wireless Charger
Please read the manual carefully before using
1. Please
place your charge device on the suitable position ( reference on the last page);
2. Please use suitable power adapter or it will affect wireless charging efficiency.
3. Can
use dry cloth to wipe and clean the charger housing, chemical cleaners banned.
4. Please
don’t put bus card, bank card, ID card or any card with magnetic on the side of
charger during usage of charger, or it may lose storage information.
5. Avoid
of using under the conditions of low temperature, wet, dust, strong sunshine, high
temperature, crash, exposure of light, etc.
6. Disassemble
housing is not allowed.
1.
wireless charger.
2.During charging,LED indicators will fully bright when cellphone completely
stays on the induction area.
Note
: if no induction chip in your cellphone, please match and wear
a
suitable induction cover on your cellphone, then it can be charged.
Put your cellphone on the charging pad and connect suitable adapter to the
Schematic diagram of cell phone right charging status.
96.5 mm
1
3
5 m
m
100 mm
Clamp
Charging Pad
Power
input
Transverse
bracket
Vertical
support
support
1. Super-thin, suitable for home, office, travel, on the go, with high efficiency, reliability;
with several protections, meet Qi standard.
2. Charge efficiency: Maximum conversion rate 85%
3. Working condition: Temperature from -10
℃ to 30℃, humidity 0%-90%RH, sea level
below 2000 meters.
4. Storage condition: Temperature from -40
℃ to 70℃, humidity 0%-90%RH, sea level
below 5000 meters.
5. Short circuit protection: Output circuit can be cut off immediately under the condition of
no-load, with load ( full-load) and recovered to work after removal of short circuit fault.
6. Over-load ( current) protection: with over-load protection, can be recovered to work
after removal of fault, over-current value range: 1.2-1.5 A.
7. Low- voltage protection: can automatically lower output power when input voltage is
lower than 4.7 V, and will shut off output to protect main circuit if worse.
8.Over-temperature protection: will
enter into protection directly when temperature is
detected to reach over 60℃ and can be recovered to work normally when temperature
is down.
User Manual