International Products Sourcing Group WBTW110 Manuel D’Utilisation

 

13 

 

 

 

This device meets the government's requirements for exposure to radio waves. The guidelines are 

based on standards that were developed by independent scientific organizations through periodic 

and thorough evaluation of scientific studies. The standards include a substantial safety margin 

designed to assure the safety of all persons regardless of age or health. The SAR limit of USA 

(FCC) is 1.6 W/kg averaged. This Device has also been tested against this SAR limit. SAR 

information on this and other pad can be viewed on‐line at   http://www.fcc.gov/oet/ea/fccid/. 

Please use the device FCC ID number for search. This device was tested simulation typical 0mm 

to body. To maintain compliance with FCC RF exposure requirements, use accessories should 

maintain a separation distance between the user's bodies mentioned above. 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 

conditions: 

(1) This device may not cause harmful interference, and (2) this device must accept any 

interference received, including interference that may cause undesired operation. 

 

NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital 

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable 

protection against harmful interference in a residential installation. This equipment generates, uses 

and can radiate radio frequency energy and, if not installed and used in accordance with the 

instructions, may cause harmful interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular installation. If this equipment does cause 

harmful interference to radio or television reception, which can be determined by turning the 

equipment off and on, the user is encouraged to try to correct the interference by one or more of 

the following measures: 

- Reorient or relocate the receiving antenna. 

- Increase the separation between the equipment and receiver. 

-Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected. 

-Consult the dealer or an experienced radio/TV technician for help. 

 

NOTE 2: Any changes or modifications to this unit not expressly approved by the party 

responsible for compliance could void the user's authority to operate the equipment.