Shenzhen Xonetec Co. Ltd 000X1 Manuel D’Utilisation

This device complies with part 15 of the FCC rules. Operation is subject to the 

following two conditions: 

(1) this device may not cause harmful interference, and (2) this device must accept any 

 interference received,   including  interference   that   may   cause undesired operation. 

Changes or modifications not expressly approved by the party responsible for compliance 

could void the user’s authority to operate the equipment. NOTE: This equipment has 

been tested and found to comply with the limits for a Class B digital device, pursuant 

to part 15 of the FCC Rules. These limits are designed to provide reasonable protection 

against harmful interference in a residential installation. This equipment generates uses 

and can radiate radio frequency energy and, if not installed and used in accordance with 

the instructions, may cause harmful interference to radio communications. However, 

there is no guarantee that interference will not occur in a particular installation. If this 

equipment does cause harmful interference to radio or television reception, which can 

be determined by turning the equipment off and on, the user is encouraged to try to 

correct the interference by one or more of the following measures: 

‐ Reorient or relocate the receiving antenna. 

‐ Increase the separation between the equipment and receiver. 

‐ Connect the equipment into an outlet on a circuit different from that to which the receiver 

is connected. 

‐Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled 

environment. This equipment should be installed and operated with minimum distance 20cm 

between the radiator and your body. This transmitter must not be co-located or operating in 

conjunction with any other antenna or transmitter.

Model： TECKER X1

FCC ID:2AOHZ000X1