Shenzhen Wenhui Technology Development Co. Ltd. WHK001 Manuel D’Utilisation
For code function: Long press the code key for 3 seconds, LED
indicator light with flicker 1 time, wait for LED indicator light to press
the remote control button that needs to be code, control board LED
indicator light continuous flicker 3 times code success.
Clear code function: Long press code button 8 seconds, LED indicator
light with flashing, then clear code completion, clear all previously
learned remote control key code
Fourth, the use of switch instructions:
1. Please unplug the binder before using it(as shown in Figure 3)
2. Rip off the sponge protection paper randomly attached and stick it
to the corresponding position(as shown in Figure 4);
3. After the switch and controller are paired, stick the switch to the
location that needs to be installed(the wall of the adhesive switch
should be cleaned up, and the protective paper should be attached to
the wall for about one minute to make the adhesive firm);
Points for attention
1. Do not operate the electric wiring, turn off the power supply
corresponding to a good connection, check the correct and then use
power.
2. When the switch voltage is insufficient, please replace the battery in
time(when the switch battery voltage is insufficient, the remote
control distance becomes closer).