Ilumisys Inc. DBA Toggled 6201852 Manuel D’Utilisation

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

 

 

(1) This device may not cause harmful interference, and

 

 

(2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by toggled could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. 
These limits are designed to provide reasonable protection against harmful interference in a residential installation. 

This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, 
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the 
equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

•  Reorient or relocate the receiving antenna. 

•  Increase the separation between the equipment and receiver. 

•  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

•  Consult the dealer or an experienced radio/TV technician for help.

This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:

 

(1) This device may not cause interference; and

 

(2) This device must accept any interference, including interference that may cause undesired operation of the device

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est 

autorisée aux deux conditions suivantes :

 

(1) l’appareil ne doit pas produire de brouillage;

 

(2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le 

 

    fonctionnement.

In order to comply with FCC/ISED RF Exposure requirements, this device must be installed to provide at least  20 cm separation from the 

human body at all times.

Afin de se conformer aux exigences d’exposition RF FCC / ISED, cet appareil doit être installé pour fournir au moins 20 cm de séparation 

du corps humain en tout temps.

Each module is labeled with the FCC ID number and IC ID number. If the module labeling is not visible after it has been integrated into 

another device, this device must be marked with this information so that it is visible to the end-user.

Suggested markings:

“Contains FCC ID: 2ARCM-6201852, Contains IC: 24359-6201852”

1.844.864.4533

support@toggled.com

11-01896-AB 2018.10.31