Suzhou Etag-Technology Corporation ET0213 Manuel D’Utilisation

ESL Solution

unupdated labels.

Solution: The error rate of communication is less than one thousandth, the battery power is insufficient, should be

promptly checked, replace the battery.



Phenomenon: electronic label does not respond to feedback signal.

Problem analysis: the lack of battery power causes the label to not work properly.

Solution: replace the battery try again, if it can’t be resolved, we need to contact technical support for maintenance.

7. List of system products

NOTE：

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not

cause harmful interference, and (2) this device must accept any interference received, including interference that may cause

undesired operation.

Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate

this equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

RF exposure compliance statement:

This device has been evaluated to meet the general RF exposure requirement, it can be used in portable exposure condition

without restriction.

Name

Number

Unit

Note

Supermarket

management software

Sets

Optional standard and full version

SDK Interface

Sets

ESL docking interface between system and user system

Label

TBD

Base Stations and

Accessories

TBD

Console

base station, antenna 2 Root

Guide

TBD

Meters

=Number of shelves * length according to the shelf length of the

factory before the shipment , depending on the number of shelves

Fast Angle

TBD

=Number of shelves * Number of layers , depending on the

number of shelves

Cable

TBD

Meters

According to the field network distribution

Switch

Console

Standard Industrial-grade switches

Android PDA

Console