innfact Design Inc 3C-UMTKV1 Manuel D’Utilisation

This device complies with part 15 of the FCC Rules. 

Operation is subject to the following two conditions: 

(1) This device may not cause harmful interference.

(2) this device must accept any interference received, including interference 

that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible 

for compliance could void the user's authority to operate the equipment. 

This equipment has been tested and found to comply with the limits for a Class 

B digital device, pursuant to part 15 of the FCC Rules. 

These limits are designed to provide reasonable protection against harmful 

interference in a residential installation. 

This equipment generates uses and can radiate radio frequency energy and, if 

not installed and used in accordance with the instructions, may cause harmful 

interference to radio communications.

This equipment generates uses and can radiate radio frequency energy and, if not 

installed and used in accordance with the instructions, may cause harmful 

interference to radio communications.However, there is no guarantee that 

interference will not occur in a particular installation. If this equipment does 

cause harmful interference to radio or television reception, which can be 

determined by turning the equipment off and on, the user is encouraged to try to 

correct the interference by one or more of the following measures: 

-Reorient or relocate the receiving antenna. 

-Increase the separation between the equipment and receiver. 

-Connect the equipment into an outlet on a circuit different from that to which the

  receiver is connected. 

-Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. 

The device can be used in portable exposure condition without restriction.

Model:3C-UMTK-V1