Hangzhou NUVO Electronics Co. Ltd. 95A042 Manuel D’Utilisation

 

BLUETOOTH 
 
To pair a Bluetooth device to the BRIM, simply find the BRIM in the list of Bluetooth 
devices and connect.  When a Bluetooth device is paired with the BRIM, the LED 
above the HAI logo will glow blue, and then you can play audio from application 
running on the device (such as Pandora, Spotify, Rhapsody, iTunes, and YouTube) in 
any Hi-Fi2 audio zone. 
 

IR OUTPUT 
 
Each BRIM ships with an IR flasher (62A08-1).  The IR flasher is used for sending IR 
data to the source equipment.  When you point your source equipment remote control 
at the IR receiver in the VSC and send a signal, the IR data is routed to the appropriate 
BRIM (to which the source is connected), which then sends the IR signal through the 
IR flasher to the source equipment.  

 
 

 
 
 
 
 
FEDERAL COMMUNICATIONS COMMISSION 
INTERFERENCE STATEMENT 
 
This device complies with Part 15 of the FCC Rules.  Operation is subject to the condition that this device does not cause harmful interference. 
 
This mobile device meets guidelines for exposure to radio waves.  Your mobile device is a radio transmitter and receiver.  It is designed not to exceed the limits for 
exposure to radio waves recommended by international guidelines. 
 
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.  These limits are designed to 
provide reasonable protection against harmful interference in a residential installation.  This equipment generates, uses, and can radiate radio frequency energy and, if 
not installed and used in accordance with the instructions, may cause harmful interference to radio communications.  However, there is no guarantee that interference 
will not occur in a particular installation.  If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the 
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 
 
--Reorient or relocate the receiving antenna. 
--Increase the separation between the equipment and receiver. 
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 
--Consult the dealer or an experienced radio/TV technician for help. 
 
CAUTION: 
 
Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment.  Body-worn operations are 
restricted to belt-clips, holsters, or similar accessories that have no metallic component in the assembly and must provide at least 1.5 cm separation between the device 
and the user’s body. 
 
RF exposure warning: 
 
The equipment complies with FCC RF exposure limits set forth for an uncontrolled environment.  The equipment must not be co-located or operating in conjunction 
with any other antenna or transmitter. 
 
IC Radiation Exposure Statement for Canada 
 
This device complies with Industry Canada license-exempt RSS standard(s).  Operation is subject to the following two conditions: (1) this device may not cause 
interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. 
 
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions 
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est 
susceptible d'en compromettre le fonctionnement. 

IR

SOURCE EQUIPMENT

(FRONT)

IR RECEIVER

WINDOW

IR FLASHER

ir out

audio in