RadioShack Corporation 120362 Manuel D’Utilisation
©2007.
RadioShack Corporation. All rights reserved. Accurian is a registered trademark used by RadioShack Corporation.
This product is not designed, manufactured, sponsored, or endorsed by Apple Computer, Inc. iPod is a trademark of Apple Computer, Inc., registered in the U.S. and other countries.
12-362
09A06
P/N: AO0294AAA1
Printed in China
Thank you for purchasing your FM transmitter
from
RadioShack. Please read this user’s guide
before installing, setting up, or using your new FM
transmitter.
What’s Included
FM Transmitter
USB Cable
User’s Guide
Specifications
Audio input ................................. 30-pin connector from iPod
Transmitting freq. ............ 88.1-107.9 MHz with 0.2 MHz step
Modulation ................................................................ FM stereo
Operating range ...................................................... 10 - 30 feet
Specifications are subject to change and improvement
Transmitting freq. ............ 88.1-107.9 MHz with 0.2 MHz step
Modulation ................................................................ FM stereo
Operating range ...................................................... 10 - 30 feet
Specifications are subject to change and improvement
without notice. Actual product may vary from the images
found in this document.
RF Emissions
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult your local
RadioShack store or an experienced radio/TV
technician for help.
If you cannot eliminate the interference, the FCC requires that you
stop using your equipment. Changes or modifications not expressly
approved by
RadioShack may cause interference and void the
user’s authority to operate the equipment.
This device complies with Part 15 of the FCC rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause
undesired operation.
Limited 90-Day Warranty
This product is warranted by
RadioShack against manufacturing
defects in material and workmanship under normal use for ninety
(90) days from the date of purchase from authorized
RadioShack
dealers. For complete warranty details and exclusions, check with
your dealer or contact
RadioShack directly.
RadioShack Customer Relations
300 RadioShack Circle, Fort Worth, TX 76102
04/04
12-362
FM Transmitter
IMPORTANT SAFETY INFORMATION
Connect and operate this product BEFORE operating your
vehicle and pay attention to the road. Attempting to drive
vehicle and pay attention to the road. Attempting to drive
and scan your set at the same time can cause a serious
traffic accident! Drive responsibly.
traffic accident! Drive responsibly.
Step 1: Connect the Transmitter
Plug the FM transmitter into the iPod dock connector and
begin playing music, the FM transmitter powers on and
begin playing music, the FM transmitter powers on and
displays the last used frequency.
To change the frequency, press or .
Note: If your FM transmitter does not power on after
connecting to the iPod, press § on your iPod twice.
To change the frequency, press or .
Note: If your FM transmitter does not power on after
connecting to the iPod, press § on your iPod twice.
Step 2: Tune Your Radio
Tune your FM radio to the frequency displayed on the
transmitter.
transmitter.
Step 3: Listen to Your Music
To listen to your music, use the volume controls on the radio
to adjust the volume.
Note: The volume control on your iPod does not control the
sound on the radio.
to adjust the volume.
Note: The volume control on your iPod does not control the
sound on the radio.
Connect to your iPod
Saving Frequencies
1. Press or to tune the desired frequency.
2. Press and hold M until M1 flashes.
3. To save a frequency in M2, press or to select M2
2. Press and hold M until M1 flashes.
3. To save a frequency in M2, press or to select M2
and hold M to store the memory location. Then, tune
a frequency and Press and hold
a frequency and Press and hold
Press and hold M until M2 flashes.
Selecting a Saved Frequency
1. Press M once for M1, M1 and its frequency appear.
2. Press M again for M2, M2 and its frequency appear.
2. Press M again for M2, M2 and its frequency appear.
To charge your iPod,
connect the supplied USB
connect the supplied USB
cable to the transmitter
and to your computer.
and to your computer.