Electrolux Home Products ELU81A Manuel D’Utilisation
TABLE OF CONTENTS
TX FCC ID: ABMELU81A
Note: The user interface (Control Panel) and
receiver( Freezer Mate) have been tested and found
to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the
following measures:
to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
receiver is connected.
- Consult the dealer or an experienced
radio/TV technician for help.
Changes or modifications to the transmitter or
receiver not expressly approved by the party
responsible for compliance could void the user’s
authority to operate the equipment.
receiver not expressly approved by the party
responsible for compliance could void the user’s
authority to operate the equipment.
BATTERY INSTALLATION
This system requires the installation of a
standard 9-volt battery (not included). The
system will not function as intended, without the
battery being installed. Please locate the battery
holder as described in the following illustrations.
Remove cover(S), hook up the connector, slide
battery and excess wire into the compartment
and replace covers.
standard 9-volt battery (not included). The
system will not function as intended, without the
battery being installed. Please locate the battery
holder as described in the following illustrations.
Remove cover(S), hook up the connector, slide
battery and excess wire into the compartment
and replace covers.
Figure: Battery Installation for Upright Style
Freezer.
Figure: Battery Installation for Chest Type
Freezer
Figure: User Interface (Control Panel).